Can you tell me how to round the edges and corners once I have the tabletop and benches poured? I would assume they can be sanded but how would I repolish them?

Once you have finished pouring your tabletop, you will see drips of epoxy because epoxy was allowed to run over the sides that look like icicles.
These drips can be sanded off once the epoxy has cured. Sand the sides smooth with 200-300 grit sandpaper. Wipe clean with acetone on a clean cloth and then apply a coat of epoxy with a paintbrush. You will want to use the heat gun or plumber’s torch to remove any brush strokes.

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments

0 comments

Article is closed for comments.